​FERMZILLA PRESSURE LID KIT

The FermZilla Pressure Lid Kit is a perfect way to upgrade the FermZilla All Rounder or Tri-Conical to allow the Brewer to add yeast, hops or even take samples from a wine thief from the top without having to remove the entire lid.

The FermZilla Pressure Lid was designed in order to suit a growing number of Brewers who wish to dry hop without exposing the entire batch to oxygen by opening the lid.

Additional Information:

The FermZilla Tri-Clover Lid can be used in conjunction with the FermZilla 2" Butterfly Valve and Hop Bong Kit, this would allow the Brewer to purge CO² into the tube and expelling all the oxygen and then dump freely into the vessel.

Includes:

1 x 2” Tri-Clover x PCO1811 Male Thread with PCO1881 Bottle Cap (KL23627)

1 x 2” Tri-Clover Clamp (KL03322)

1 x 2” Tri-Clover Beaded Silicone Seal (KL03438)

Features Include:

2 x PCO1881 Male Ports

1 x Pressure Relief Valve Port - Includes Red 35psi/2.5bar Pressure Relief Valve

1 x Tri-Clover Ferrule – 2”

Undrilled Ports:

1 x Thermowell Port (8mm DuoTight x ¼" Bulkhead) Suitable for 60cm Thermowell DuoTight Kit

2 x Ice Water / Glycol Temp Twister Ports (9.5mm DuoTight x ½" Bulkheads)

The Temp Twister will need to be bent on a 20° angle in order to fit on the curved lid and align vertically in the tank.

PLEASE NOTE:

Release the pressure completely before opening the 2" Tri-Clover.

Only use KegLand Red 35psi/2.5bar Pressure Relief Valve with the lid.

Ensure the PRV is cleaned and dried of sticky residue before each fermentation. Failure to do so could cause injury and void warranty.